|
|
|
|
DODGE 1500 2002-2005 1500 2006-2008 2500/3500 1994-2002 2500-3500 2003-2009 FORD SUPER DUTY/ EXCURSION1999-2007 SUPER DUTY/EXCURSION 2008-2009 F-150/EXPEDITION 2004-2008 F-150/EXPEDITION 1997-2003 GM GM HD 2002-2007 GM HD 2007-2009 TAHOE/SUB/YUKON/1500 2000-2006 gm 1500 2007-2009 HUMMER JEEP JEEP WRANGLER 1997-2006 NISSAN TITAN 2004-2009 TOYOTA FJ CRUISER 2006-2009 TACOMA 1995.5-2004 TACOMA 2005-2009 TUNDRA 2004-2006 TUNDRA 2007-2009 YAMAHA rhino side x side
|
SLEEKSTER LIGHT BAR BY RANDY ELLIS DESIGN, INC. 02’-05’
DODGE 1500 Light bar instructions part# 3105 U.S. DESIGN PATENT NO. D521,923 On
sport model trucks the light bar brackets may interfere with the bumper cover,
touching the under side of the bumper opening. 1.
If your Dodge does not have factory tow hooks go to step 7. 2.
If your Dodge has factory tow hooks, remove the tow hook. 3.
Locate your new light bar so the brackets will sandwich between the tow
hook and the frame. NOTE: The light bar needs to be “rolled” into place by
inserting the lower end of the brackets into the opening first and “rolling”
it up into position. 4.
Use the supplied 3/16 spacers for the inner hook bolts. (They will space
the tow hook out the same amount as the light bar brackets.) 5.
Re-install the tow hooks, using the factory tow hook bolts with the bolts
going through the tow hook, the light bar bracket and then the frame brackets,
and the inner tow hook bolts going through the tow hook, 3/16 spacer then the
frame. 6.
Align the light bar side to side until it is centered in the opening and
then tighten all hardware. 7.
If your dodge does not have the factory tow hooks remove the plastic
filler panels or panel in the opening of the middle of the bumper. NOTE: Factory
tow hooks and hardware can be purchased at your local Dodge dealership if you
would like to install tow hooks at this time. Tow hooks are not necessary for
the installation of the light bar. 8.
Notice the 2 holes in the frame on some models and/or 1 hole on each side
that line up with the light bar brackets. NOTE: If only using 1 hole on each
side the center hole in the light bar bracket will be used. 9.
Install the light bar using the supplied hardware. Do not tighten. NOTE:
The light bar needs to be “rolled” into place by inserting the lower end of
the brackets into the opening first and “rolling” it up into position. 10.
Align the light bar side to side until it is centered in the opening and
then tighten all hardware. 11.
The factory plastic filler panel can be cut down on the ends and re-installed. Install the lights of your choice and enjoy Thank you for purchasing quality products by Randy Ellis
Design, Inc. 2855 W Fairmount Ave Phoenix AZ 85017 602-803-1122
|
ARB 4x4 Accessories
OPTIMA BATTERIES The Ultimate Power Source
ENGEL USA Portable Fridge/Freezer
|
|