07-09 gm hd 4 tab instructions

Your new Sleekster light bar will mount to the outsides of each frame rail using the two bumper mounting bolts and one of the bolts for each tow hook.
Remove the nuts from the passenger side bumper bolts and nut from the tow hook bolt that goes through the frame. The bolts will need to be pushed into the frame flush with the outside. NOTE: The lower bolt in the tow hook may need to be loosened.
Remove the nuts and bolts from the drivers side bumper bracket and tow hook. Insert the bumper mounting bolts from the inside of the frame so they are a mirror image of the passenger side bumper mounting bolts.
Hold the light bar in position with the two upper mounting holes of the light bar aligned with the bumper mounting bolts and the lower mounting hole with the tow hook bolt.
Insert the supplied spacer between the frame and light bar bracket and insert the tow hook bolt on both passenger and driver side.
Insert the bumper mounting bolts through the light bar brackets and start the nuts.
Tighten all hardware.
Install the lights of your choice and enjoy!

Thank you for purchasing quality products from

Randy Ellis Design, Inc.

2855 W. Fairmount Ave. Phoenix, AZ 85017

www.RandyEllisDesign.com

602-803-1122