|
|
RANDY ELLIS DESIGN |
|
|
|
SUPER DUTY/ EXCURSION LIGHT BAR
|
SLEEKSTER
LIGHT BAR BY
RANDY ELLIS DESIGN, INC. TOYOTA
FJ LIGHT BAR INSTRUCTIONS
PART #5205 SUPPLIED
HARDWARE:
2: 12mm-1.75 x 70 BOLTS
2: 12mm LOCK WASHER
2: SPACERS 1: LOCATE
THE 3 STUDS ON THE FRONT OF EACH FRAME RAIL, BEHIND THE BUMPER COVER.
NOTE: THESE ARE THE 3 STUDS POINTING FORWARDS TOWARDS THE
OUTSIDE. 2: REMOVE
THE NUTS FROM EACH OF THE THREE STUDS.
NOTE: DO NOT
DISCARD THE NUTS, AS THEY WILL BE REUSED. 3: POSITION
THE LIGHT BAR BRACKETS OVER THE 3 STUDS ON EACH SIDE THAT YOU REMOVED THE NUTS
FROM. 4: LOOSELY
INSTALL THE UPPER NUT ON THE LEFT AND RIGHT STUDS ON THE FRONT OF THE FRAME
RAILS. 5: LOCATE
THE HOLE TOWARDS THE REAR OF EACH LIGHT BAR BRACKET. 6: PLACE THE
SUPPLIED SPACER BETWEEN THE LIGHT BAR BRACKET AND THE FRAME. LINED UP WITH THE
REARWARD HOLE IN EACH LIGHT BAR BRACKET. 7: INSERT
AND START THE SUPPLIED BOLT WITH LOCK WASHER THROUGH THE LIGHT BAR BRACKET, THE
SPACER, AND INTO THE THREADED HOLE OF THE FRAME.
NOTE: DO
NOT TIGHTEN THE BOLTS AT THIS TIME. 8: INSTALL
THE REMAINING NUTS AND TIGHTEN THE NUTS ON THE 3 STUDS ON EACH SIDE OF THE
FRAME. 9: TIGHTEN
THE SUPPLIED 12 mm BOLTS INTO THE FRAME.
THANK YOU FOR PURCHASING QUALITY PRODUCTS FROM RANDY ELLIS DESIGN, INC. 2855 W FAIRMOUNT AVE. PHOENIX, AZ 85017 WWW.RANDYELLISDESIGN.COM 602-803-1122 EMAIL: TO HELP ELIMINATE SPAM, PLEASE RE-TYPE THE EMAIL ADDRESS INTO AN EMAIL. THANKS!
U.S. DESIGN PATENT NO. D521,923
|
|
|
